Operation12. Adjust the needle valve to set the pump cycle rateat 1 stroke every 15 seconds.13. Turn the heater dial to 3. Whenever the heater set-tin
Operationv.Production SprayingYou are now ready for production spraying. If you stopspraying for more than 30 minutes, turn off the heaterto prevent o
Flushina+a14.15.KEYABleed-type master air valveC Air line3 Fluid heater6a Pump air regulator6b Gun air regulator93-way valve13Drain hose44 Fluid regul
PartsModel 237410, Series ARef PartNo. No.1235-2302217-7523220-5224 110-1605108-2336111-8047 11 O-2098108-l 909 214-71110214-69911205-l 6912206-966132
Parts16’Model 237410, Series A2560 /23308-448 13
Notes.14 308-448
Notesc308-448 15
Technical DataManual Change SummaryThe current revision of this manual includes thefollowing changes:Page 12, Parts List:lThe quantity of item 25 (el
3X8–448Rev. FSupersedes Rev. CIncludes Rev. D and E changesParts Change NoticeSome parts in Rev. C of manual 308–448 have changed but have not yet be
Table of ContentsSymbolsWarnings...2Setup.. ...4System Component Information ..
EQUIPMENT MISUSE HAZARDEquipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and resultin serious injury.00l0000000T
A CAUTIONThis equipment is compatible with most waterbased materials. See the wetted parts in the Tech-nical Data section and your fluid and solventma
III.Unpacking the SystemIn addition to the assembled unit, these componentsare packed loosely or separately: suction assembly,hose set, gun, instructi
System Component InformationVI.Using the G700N Air Spray Gun1.2.3.4.5.6.7.Refer to Fig. 3.Make initial fluid and air adjustments at the pumpfor maximu
System Component InformationVIII. Using the Air Regulators and Needle1.2.3.4.5.valve See Fig. 5.Always open air and fluid regulators slowly to pre-ven
OperationI.Pressure Relief ProcedureThe system remains pressurized until pressure ismanually relieved. To reduce the risk of seriousinjury from pressu
Comments to this Manuals