Haier GDZ22-2 User Manual download pdf (Page 23)

1. Remove the screws securing the terminal block access cover

and the strain relief mounting bracket located on the back of the

dryer in the upper corner.

2. Install a strain relief into the power cord entry hole of the

mounting bracket. Finger tighten the nut only at this time.

3. Thread a 30 Amp. Power cord, 245 IEC66(YCW) 450V/750V,

through the strain relief.

4. Attach the power cable earthconductor to the silver

coloured centre terminal on the terminal block. Tighten

the screw securely.

5. Attach the remaining two power cable outer conductors to the

outer silver coloured terminals on the terminal block. Tighten both

screws securely. Warning:Do not make a sharp bend or crimp

wiring/conductor at connections.

6. Reattach the strain relief mounting bracket to the back of the dryer

with two screws. Tighten screws securely.

7. Tighten the screws securing the cable restraint firmly against the

power cable.

8. Tighten the tension relief nut securely so that the tension relief

does not turn.

9. Reinstall the terminal block cover.

Grounding

instruction:

This appliances must be connected to a ground metal,

permanent wiring system, or an equipment-grounding

conductor must be run with the circuit conductors and

connected to the equipment-grounding terminal or

lead on the appliance.

3-Wire Cord Connections

nut

tighten nut

to these threads

power cord

Strain relief

mounting bracket

1 2 ... 18 19 20 21 22 23 24

No comments

Haier GDZ22-2 User Manual Page 23