Haier HLP141E Manual download pdf (Page 9)

English

Venting The Dryer

Proper venting of the dryer is very important. Determine the best and safest

ducting for the dryer.

Exhaust Requirements and Maintenance.

Clothes dryer installation must be performed by qualiﬁed installer.1.

Install the clothes dryer according to the manufacturer’s instructions and local codes.2.

Do not install a clothes dryer with ﬂexible plastic venting materials. If ﬂexible metal 3.

(foil type) duct is installed, it must be of a speciﬁc type identiﬁed by the ﬂexible duct

manufacturer as suitable for use with clothes dryers. Flexible venting materials are

known to collapse, be easily crushed, and trap lint. These conditions will obstruct

clothes dryer airﬂow and increase the risk of ﬁre.

Clean old ducts before installing this dryer.4.

WARNING!

Outside

Vent

Correct Incorrect

Venting must conform to local building codes.•

Do not use thin plastic or foil ducting.•

Use 4 inches (10.2cm) diameter rigid or flexible metal duct (note: venting •

materials are not supplied with the dryer, and you should obtain the venting

materials necessary for proper installation at your local hardware store).

Position the Dryer such that the exhaust duct run is as short as possible. •

Make sure there is no more than 6 feet of exhaust ducting.

Clean old ducts before installing this dryer•

Never bend or collapse ducting flex hose. Use few elbows joints as needed.•

Use duct tape on all duct joints.•

Insulate ductwork that runs through unheated areas in order to reduce •

condensation and lint build-up on pipe walls.

To reduce the risk of fire and combustion, the dryer must be vented outdoors. Lint

accumulation can cause fires. Check and clean vents and ducting as often as possible.

PLEASE BE AWARE THAT FAILURE TO EXHAUST THE DRYER CORRECTLY WILL VOID THE

DRYER’S WARRANTY.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 61 62

No comments

Haier HLP141E Manual Page 9