Haier IPDS-10 User Manual download pdf (Page 8)

REMOTE CONTROL

Using The Remote Control

The CR2032 lithium battery is already installed in the remote control. Pull out the small

mylar insulation tab as shown in the illustration to begin using the remote control.

To use the remote controller, point the remote control transmitter on the remote control

toward the remote control receiver on the front panel of the main unit and press the desired

button. The effective range of the remote controller is approximately 20 feet. Please note that

bright sunlight or artificial light may interfere with the proper operation of the remote control.

When the remote operation becomes weak or intermittent, it is time to replace the remote

control battery. Pull out the battery holder, remove the old battery and install a new CR2032

battery in the holder as shown in the illustration. Slide the holder back into the remote

control.

NOTE: If the battery is installed incorrectly the remote control will not work.

Battery Replacement

• Make sure that you have removed

the mlar insulation tab from the

remote control.

• Ensure the system is connected to an AC outlet that is always “live”.

1. Remote Control Transmitter

2 Power Button

3. iPod MENU + Button

4. SKIP Button

5. ENTER Button

6. Button

7. PLAY / PAUSE Button

8. VIDEO OUT Button

9. VOLUME Button

10. ROTATE Button

11. Button

12. MENU Button

13. 3D SOUND Button

14. VOLUME Button

iPod MENU -

SKIP

PULL

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

No comments

Haier IPDS-10 User Manual Page 8