Haier P50V6-A8S User Manual download pdf (Page 47)

Troubleshooting

For the sake of time and cost, it is strongly recommended that you check out

the problem by yourself according to the instructions listed hereunder before

contacting the after-sales service for technical assistance.

Note: Production of the plasma screen requires high and precision technologies. However,

there might be some dark or bright (red, blue or green) spots, or some anomalistic stripes or

spots. This is not defect. If the TV set is used in an area 2,400 meters above the sea level where the air

pressure is below 750hpa, the picture on the plasma screen may be affected and a muffled sound might

be produced. These phenomena might happen in the area 1,500 meters above the sea level. This is

resulted from difference between air pressures inside and outside the display. This is not a defect covered by

the limited warranty.

NOTE: Design and specifications are subject to change without notice.

The dimension in this manual is a approximation.

Note: Do not leave the television with static picture in an extended period as it may result in

residual image on your television screen.

Horizontal/vertical bars

or picture shaking

Check for local interference such as an electrical

appliance or power tool.

No picture, no sound

Verify if the television is properly plugged.

Verify if the television is properly supplied power.

Verify if electricity is available.

Blank screen

Verify if correct signals are input.

Press TV/AV button to change signal input to TV input.

Restart the television of power supply is interrupted.

No sound

Press Mute button and verify if Mute mode is set.

Switch to other channel and verify if the same problem

happens.

Press VOL+ button to see if the problem can be solved.

Poor sound

Verify if sound system is correct. Refer to some chapter

for adjust.

No picture in some

channel

Verify if correct channel is selected.

Adjust the antenna.

Make adjustments by Fine Tune and Manual Search.

No color for some

channel program

(black and white)

Verify if the same problem exists in other channels.

Check out of picture and sound systems.

Refer to relative instructions in the Manual for color

adjust.

Spots with some or

all pictures

Verify if the antenna is correctly connected.

Verify if the antenna is in good condition.

Make fine adjustment of channel.

Television out of control

Disconnect the television from power supply and, 10

seconds later, connect the television to the power supply.

If the problem still exists, contact authorized after-sales

service for technical assistance.

1 2 ... 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Haier P50V6-A8S User Manual Page 47

Comments to this Manuals

Related products and manuals for LCD TVs Haier P50V6-A8S