Haier HSU-09RC03/R2(DB) User Manual download pdf (Page 17)

Remote Controller

Operation

Hints:

After replacing batteries or a power failure happens, time setting should be reset.

Remote controller possesses memory function, when use TIMER mode next time,just

press SET button after mode selecting if time setting is the same as previous one.

Set clock correctly before starting TIMER operation.

1. After unit starts, select your desired operation mode

Operation mode will be displayed on LCD.

2. Timer mode selection

Press TIMER button to change TIMER mode. Every time

the button is pressed, display changes as follows:

Remote controller:

BLANK

TIMER ON TIMER OFF TIMER ON-OFF

Then select your desired TIMER mode (TIMER ON or

TIMER OFF). " "or " "will flash.

3.Time setting

Press HOUR button.

Every time the button is pressed, time setting

increases 1 min , if kept depressed, it will increase

rapidly.

Every time the button is pressed, time setting

decreases 1 min, if kept depressed, it will decrease

rapidly.

It can be adjusted within 24 hours.

4.Confirming your setting

After setting correct time, press SET button to confirm

" "or" "on the remote controller stops flashing.

Time displayed: Unit starts or stops at x hour x min.

(TIMER ON or TIMER OFF).

5.Cancel TIMER mode

Just press TIMER button several times until TIMER

mode disappears.

Timer On/Off Operation

Display panel

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

No comments

Haier HSU-09RC03/R2(DB) User Manual Page 17