Haier HBU-36HH03 User Manual download pdf (Page 25)

3. Install ornament panel on indoor unit.

Tighten screws to redrce the thickness of seals

between ornament

and indoor unit to 5-8mm.

If indoor unit is at horizontal level and water drainage is

smooth, then, indoor unit height can be adjusted throrgh

holes at corners of ornament panel.

If screws are not tighten tight, problems in Fig.3 might

occur.

Tighten screws properly.

If there are still space after tightening of screws,

please readjust the height of indoor unit.

Gas leakage.

Gas leakage

from roof.

Contamination

Mist exists and drop down.

For indoor unit installation, please refer to Installation Manual.

2. Mounting on high ceiling

If connecting is not made, error code (A7) appears

on remote controller. So, make proper connecting.

Side of ornament panel

Side of indoor unit

Check whether indoor unit is horizontal with leveler or polythene pipe filled with water , and check that the dimension

of the ceiling opening is correct. Take off the lever gauge before install the ornament panel.

Fasten the screws to make the height difference between the two sides of

indoor unit less than 5mm.

First fix it with screws temporally.

Fasten the two temporally fixing screws and other two, and tighten the

four screws.

Connect the wires of synchro-motor.

Connect the wire of signal.

If no response of remote controller,check whether the wiring is correct,

restart remote controller 10 seconds after shut off power supply.

Swing motor

Where the swing motor locates in the figure of panle just is the location

of liquide pipe.

Caution

Seal

Indoor unit

Ceiling material

Ornament panel

8mm

Leave no space.

Installation Procedure

Electric control box

1 2 ... 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Haier HBU-36HH03 User Manual Page 25

Comments to this Manuals

Related products and manuals for Power heat guns Haier HBU-36HH03