8
5
6
Setting Environment
Description of the Symbols
Do not set it at place where is too cold and
may freeze.
Do not set at outdoor places.
Do not use as floorstanding appliance.
Please mount it to firm and reliable wall.
Do not install to places without sewer.
In case connecting water heater with water drain hose,
connect the drain hose to the inlet of the sewer to avoid
polluting by splashing.
The original pipeline of the water heater is an organic part of "PTO 0". Do not remove it by yourself.
Otherwise we will not take responsibility for the injure and loss caused by the safety trouble occurred
therefrom.
Never do that
Be sure to act as per instructions
Installation
Be sure to have it installed by installation staff of the after service
department, or the appointed staff. It adopts wall-mounting installation.
Make four holes with diameter of 12mm and depth 65mm with churn drill
on the wall as per the installation dimension drawing. Insert the bolts into
the holes. Then lift the water heater, set the wall-mounting rack on the bolt.
Set the gasket and fasten the nut. Install the accessories including safety
valve etc. as indicated in Figure 2. Remember to seal with rubber tape to
avoid water leakage.
The hot water pipe shall not be too long to reduce the heat losses.
Please reserve some space in installation for the future maintenance.
To facilitate the installation and dismantling, it is suggested to add G 1/2'
flexible nut at the suitable position of the water inlet and outlet pipe
separately. Confirm the position needing water supply. Connect the water
inlet/outlet pipe and tap water pipe to the position respectively.
(Figure 2) for reference in installation only
Cold water inlet
Mixing valve
Hot water
outlet valve
Cold water
outlet valve
Shower nozzle
Hot
water
outlet
Safety valve
Connection and use of safety valve:
The safety valve should be connected to the cold water inlet pipe. Please
check carefully if the direction is correct after installation. The correct
direction of installation is that the arrowhead on the safety valve should
point to the water heater.
Please connect the drain hose to the safety valve. Connect one end of the
hose to the safety valve vent and the other end to the sewage drain. The
hose can be cut short or extended as necessary. The hose shall be installed
as inclined downward.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals