Haier QBJ1-150A58E User Manual download pdf (Page 11)

1. Any alteration to the structure of the solar water heater may cause the trouble

while using it.

2. There are 5 connection methods of the water pipe into the room, they are smoke

way, vent-pipe hole on the wall appropriative solar well prepared cannula

and the first three kinds are common. Before the installation, our professional

will consult the room's situation and choose the suitable location to bring you

convenience. A upend slope is necessary ,and should be wind-tight to prevent

the rainy water or smell's entrance.

3. Keep the placket of the overflow pipe downwards and fasten it so that the liquid

can be lead to the cloaca directly, and please notice that the distance of the

overflow pipe and the cloaca should less than 15cm. Don't placed the pipe

optionally, so can avoid the water spatter.

4. Don't install the valve in the pipeline to insure that the signal which shows the

water is overflow will be worked normally.

5.To avoid the water in the tank flow inverted, an unilateralism valve should be

installed at the joint of the water pipe and the tap water.

6. The installation project should be confirmed by our professional service

personnel when install several sets of these series.

Assembly Instruction

Please install another one-

directional valve at the cold and hot

water pipes if the solar tank is

connected with other kinds of tanks

to avoid the exceed pressure in

these tanks flowing backwards to

the solar tank and lead accidents.

Other

water heaters

Tap water

Contact to the water tank

Illustration of connect the solar tank with other tanks

Hot water

Installation notice

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Haier QBJ1-150A58E User Manual Page 11