No.*Please read this manual carefully before usingPlease keep this manual for future useAB422BCBAA0010571740 Haier Network Air ConditionerTwo by One R
AUTO COOLING DEHUMIDIFYING HEATING FANAUTOLOW FAN MED FAN HIGH FAN AUTOSETMODE FAN SWINGTEMPCLOCKTIMERSETSLEEPFILTER
Operation instruction SwingSETMODE FAN SWINGTEMPCLOCKTIMERSETSLEEPFILTER RESETRESETON/OFFHEAT9Fixed air sending directionWhen the Auto SWING of the ai
Set temperatureSLEEP operation startsSLEEP operation stopsturn off1 hourabout 3 hours3 hoursdecrease 2*increase 1* in HEATING operation1 hourdecrease
Operation instructionTimer On/Off functionSETMODE FAN SWINGTEMPCLOCKTIMERSETSLEEPFILTER RESETRESETON/OFFHEAT11Before using TIMER function, calibrate t
SETMODE FAN SWINGTEMPCLOCKTIMERSETSLEEPFILTER RESETRESETON/OFFHEAT5612Then confirm the Timer mode is theTIMER ON-OFF mode.At this time the* *will fl
13Usersí AttentionDo not put any dryingdevices underthe indoor unit.The heat may causethe deformation ofindoor unit.Cooling is26~28*Heating is18~23*Se
Maintenance Donít inoperationDaily maintenanceClean the air filterInstructions: When not for cleaning, do not dismantle the air filter, otherwise it
15Clean the air filter2.Dismantle the air filter Pull the two side handles at the back of the air inlet grille, lift the air filter to dismantle
16Clean the air inlet grille1.Open air inlet grille Pull the two handles at the same time, slowly draw them out. (when closing it, the proce
17Clean the air outlet and casingNoticeDo not use gasoline, benzene, diluent, polish powder or liquid pesticideto clean.Do not use the hot water over
Characteristics of ProductsFar distance monitoringThere is a pre-set far distance control communication interface on the controlpanel of indoor unit.
18Maintenance1.Check the following items: If the air inlet and outlet of indoor and outdoor unit are blocked. If the earth wire is prope
TroubleshootingThe following phenomena are not troublesSymptom CauseThe unit doesnot workThe unitblows outmist.The unitgives outnoiseThe unitblows out
When Troubles OccurBefore contacting the commissioned repair center for after-sales service, please check yourair conditioner according to the followi
21Installation instructionBefore installing, do read this ìSafety precautionsî carefully to guarantee the proper installation.The below attentive matt
Refrigerant oilCementsteel nailPlastic1261Installationpaper panel31425Big wireclamp26ThermalinsulationpipeDrainhose8Sealcushion4278Gasket111012 13 142
Installation procedureInstall indoor unit23Space installation needed (unit: mm)Over 1500Air inletAir discharging hole300Loud 1000Over 1500Air discharg
Installation procedureInstall indoor unit243.Preparation before installation(1) The position relation among ceiling opening and hoisting screws (unit:
25Suspending poleHoisting screw4 edges together(1) Temporarily install the indoor unit Attach the hoisting foot on the hoisting screw. The screw n
Installation procedureInstall indoor unit45 2Specification of pipe (mm)TorqueDimension of cone A (mm)Cone*9.52*15.8812.0~12.418.6~19.
Installation procedureInstall indoor unitThe drain hose should be as short as possible. The droop slant degree at leastshould be 1/100 to avoid formin
Far distance monitoring There is a pre-set far distance control communication interface on the control panel of indoor unit. After installing the
Installation procedureInstall indoor unit28Test of drainage system(a)After finishing the electric work, perform the test to the drainage system.(b)Dur
Installation procedureInstall indoor unit<The wiring method of the connection of the unit>Connect the unitRemove the electric box cover (1), dra
Installation procedureInstall the decorative panel1. Preparation of decorative panelThe treatment of decorative panelThe decorative panel cannot be pu
Installation procedureInstall the decorative panelNoticeIf fastening the screws improperly, itmay cause the trouble as Figure 5 shown.The screw should
Installation procedureInstall the decorative panel(3)The circuit of the decorative panel Connect the wire end of the louver motor installed on the
Installation procedureConnection of pipeThe attentive matters in connection of pipe5.Thermal insulation treatment The thermal insulation of connec
(Sketch map)34Installation procedureElectric wiringConnect wire between indoor & outdoor unit Remove the air inlet grille, open the electric box
Operation pointsAnti-cold air blowing outDuring Heating operation, after starting the unit,the indoor fan motor will not rotate immediatelyto prevent
Wire ControllerHEATAUTOSETROOMMODE FAN SWINGTEMPCLOCK SETTIMER SLEEPRESETFILTER RESETON/OFFName of PartsIndoor UnitAir outletAir filter(inside of air
Wire Controller14.Network control displayUsed to adjust the time oftimer and clockWhen the wire controllerappears abnormalcondition, use a sharp-point
5Safety PrecautionsWarning******************** : Those contents marked with ìProhibitionî are definitely prohibited action, otherwise, it may c
6Safety PrecautionsNoticeDo not use wet hands tooperate the air conditioner.Otherwise, it may causeelectric shock.Only use the properspecified fuse. D
Fan operationAbout FAN operation:FAN operation refers the air conditioner does not perform COOLING andHEATING operation, but FAN operation. In this mo
Comments to this Manuals