Start
WALL MOUNTING INSTRUCTIONS1. Determine the location of the dryer on the wall and mark the bracket position. A minimum 50 mm is needed between t
WALL MOUNTING INSTRUCTIONS3. Install the hooks to the dryer, in the inverted position, remove the 2 screws and 2 plastic plugs as indicated in Fig
WALL MOUNTING INSTRUCTIONS5. With assistance, mount dryer on wall brackets. See Fig. 36. A second control panel with inverted symbols is supplied.
RACK FITTING INSTRUCTIONDRYER FREE STANDING-UPRIGHTFor ease of access, the rack is to be mounted near the dryer top. Firstly,hold the rack horizontall
RACK FITTING INSTRUCTIONRACK STORAGE - DRYER INVERTED.To hold the dryer rack out of the waywhen not in use, it will be necessary toattach the retainin
14The following must be confirmed before calling for service:Problem Possible CauseThe dryer does not startThe drying resul
Power supplyMaximum operating current (A)Rated load (kg)Maximum power (W)Dimensions (HxDxW) mmWeight (kg)220-240)V~/50Hz1062100825 x 560 x 59530IPX 4W
1 Read all instructions before using this dryer.2 The interior of the dryer should be cleaned periodically by qualified service personne
2 49RACK FITTING INSTRUCTION . . . . . . . . . . . . . . . . . . . . . . . . .1241 41 15PROGRAM DESCRIPTIONS . . . . . . .
Read all instructions before using this dryer.This dryer has been designed for domestic use only.SAVE THESE INSTRUCTIONS.This diagram may be slightly
Attention:1.Before operation, clean off any dust and dirt inside the drum of the dryer with a damp towel2.Clean off any debris on the lint filter
1. Power up Insert the power plug into an appropriate power outlet that is properly installed and grounded. Operating power supply: 220-240V~50
6Please do not turn the timer knob to this gray area of the program cycle.Dryer timer: The timer will let you set the timer for up to 200 minutes to d
WARNING! Unplug the power cord prior to any cleaningCleaning the surfaceWipe off any dust or dirt.Note: Do not use excessive water,a damp cloth is fin
Remove the transport packaging (fig.1) and remove the dryer rack from the top packaging (fig.2). Remove the tape on the front (fig.3 and fig.4), the w
Comments to this Manuals