Haier WM6002A User Manual download pdf (Page 18)

The digitron displays E0.

The safety switch acts, and the

spinning cannot work. The

digitron displays E3.

The water filling does not work, or is

slow. After about 15 minutes later,

the digital displays E4.

The drainage cannot work, or is too slow.

The digitron displays E1.

It stops running in midway. The digitron

displays E2.

The power voltage is too low.

The top lid is not closed.

The top lid is opened during reserve

procedure.

Close the top lid.

Is the drain hose put down?

Is the drain hose blocked?

Put down the drain hose. Open and close the

top lid once.

Clean the foreign material. Open and close

The top Lid Once.

Are the laundries put slantingly?

Is the machine slanting?

Reorder the laundries. Close the top lid.

The machine will start running after 10

seconds of being placed horizontally.

Is the water tap opened, or is there water

supply failure?

Is the water inlet valve blocked?

Is the water pressure too low?

Open the water tap. Push the start/Pause

button once.

Clean the water inlet valve then push

the start/Pausebutton once.

Push the Start/Pause button once.

The water level sensor is bad.

Please contact the after-sales

service department.

Is the machine slanting?

Are the laundries put slantingly in spinning?

Are there any foreign materials?

Is the screw of the jointer of water

inlet hose loose or awry?

Pull off the power plug. Wait for the

voltage resuming normal before usage.

Adjust the machine to be level

Reorder the laundries and close the top lid.

Remove the foreign materials.

Fasten the screw of the jointer properly.

The water tap leaks

The digitron displays E8.

The digitron displays E6.

There's abnormal sound

inside the machine

Phenomenan The reason How to settle

Trouble-shooting Answer to question

(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns

sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special

maintenance department or after-sale service department of our company. Do not repair it by yourself.

The digitron displays E9.

The power voltage is too high.

The machine does

not act

Not wash

Not spin

Is there power failure?

Is the power plug inserted tightly?

Is the water level reached preset position?

Please use it when there's power supply.

Insert the power plug tightly.

Fill water to the preset position.

Is the power plug inserted tightly?

Is the top lid closed reliably?

Are the laundries set flat?

Insert the power plug tightly.

Close the top lid.

Set the laundries flat.

Common phenomena

Phenomena Explanation

* The spinning is intermittent when it starts. * Balance the laundries to avoid slanting.

* The wash procedure pauses. * The cloth sensor is detecting the cloth. It will start

adding water after about 48 seconds.

* Select “ SPIN” program, but it doesn’t work. * The program is setting the drain time. A certain

period is needed before it starts spinning.

* The pusaltor pauses during washing, rinsing

or adding water.

* It is to avoid splashing during water filling.

* There may be some water flowing out of the

drain hose in the first use of the machine.

* It is the water remained in the performance

inspection by the factory.

1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Haier WM6002A User Manual Page 18

Comments to this Manuals

Related products and manuals for Washing machines Haier WM6002A