Haier FCD-JTSA50-III User Manual download pdf (Page 6)

Setting Environment Installation

Description of the Symbols

Do not set it at place where is too cold and

may freeze.

Do not set at outdoor places

Do not use as floorstanding appliance

Please mount it to firm and reliable wall

Do not install to places without sewer

In case connecting water heater with water drain hose,

connect the drain hose to the inlet of the sewer to

avoid polluting by splashing.

The original pipeline of the water heater is an organic part of "PTO¢ñ0". Do not remove it by yourself.

Otherwise we will not take responsibility for the injure and loss caused by the safety trouble occurred therefrom.

Never do that

Be sure to act as per instructions

Be sure to have it installed by installation staff of the after service

department, or the appointed staff. It adopts wall-mounting installation.

Make four holes with diameter of 12mm and depth 65mm with churn drill on

the wall as per the installation dimension drawing. Insert the bolts into the

holes. Then lift the water heater, set the wall-mounting rack on the bolt. Set

the gasket and fasten the nut. Install the accessories including safety valve

etc. as indicated in Figure 2. Remember to seal with rubber tape to avoid

water leakage.

The hot water pipe shall not be too long to reduce the heat losses.

Please reserve some space in installation for the future maintenance.

To facilitate the installation and dismantling, it is suggested to add G 1/2'

flexible nut at the suitable position of the water inlet and outlet pipe

separately. Confirm the position needing water supply. Connect the water

inlet/outlet pipe and tap water pipe to the position respectively.

Cold water inlet

Mixing valve

Hot water

outlet valve

Cold water

outlet valve

Shower nozzle

(Figuie 2) for reference in installation only

Hot

water

outlet

Safety valve

1 2 3 4 5 6

No comments

Haier FCD-JTSA50-III User Manual Page 6