Haier HVTM06ABS User Manual download pdf (Page 6)

Installation Limitations

• Do not install your wine cellar in any location not properly insulated or heated

e.g. garage etc.

• Select a suitable location for the wine cellar on a hard even surface away from

direct sunlight or heat source e.g. radiators, baseboard heaters, cooking

appliances etc. Any surface unevenness should be corrected with the leveling

legs located on the front and rear bottom corners of the wine cellar. Avoid

placing unit where there may be electrical interference.

• Your wine cellar is designed for free-standing installation only. It is not

designed for built-in application.

NOTE: To minimize the risk of rusting, leakage and insulation

damage, avoid placing the unit in a place where heavy

moisture is present. Under no circumstances spill or directly

apply water onto or into the unit.

Door Alignment

1. Remove the top hinge cover using a flat head screwdriver.

2. Gently move wires aside and loosen the 3 screws using a Phillips Head

Screwdriver.

3. Adjust the door and tighten the screws.

4. Replace the top hinge cover.

5. Adjust bottom hinge if necessary.

Stabilization Bracket (HVTM04ABB ONLY)

To increase product stability we strongly recommend attaching the stabilization

bracket to the underside of the wine cellar.

1. Remove the bracket and 3 screws from the plastic bag.

2. Insert the screws through the holes in the bracket and then into the predrilled

holes on the bottom of the wine cellar (see image)

3. Tighten the screws

English

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

No comments

Haier HVTM06ABS User Manual Page 6