Haier hc125fvs User Manual download pdf (Page 6)

1. Remove all packaging material. This includes the foam base and all

adhesive tape holding the beverage center accessories inside and

outside.

2. Inspect and remove any remains of packing, tape or printed

materials before powering on the beverage center.

• Your beverage center has leveling legs which are located at the

bottom of your beverage center. After properly placing your beverage

center in its final position, you can level your beverage center.

• Leveling legs can be adjusted by turning them clockwise to raise your

beverage center or by turning them counterclockwise to lower your

beverage center. The beverage center door will close easier when the

leveling legs are extended.

• Also, there is an adjustable support for the lower door hinge. (see

fig.4) After leveling the Beverage Center, adjust the hinge support, up

or down as needed until it rests on the surface on which that unit is

placed.

• To assure your beverage center works at the maximum efficiency it

was designed for, you should install it in a location where there

is proper air circulation and electrical connections.

• The following are recommended clearances around the beverage

center:

Sides……………3/4 "(19mm)

Top....................2" (50mm)

Back..................2" (50mm)

Installing Your Beverage Center

Unpacking Your Beverage Center

Proper Air Circulation

Leveling Your Beverage Center

English

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

No comments

Haier hc125fvs User Manual Page 6