Haier HMV1630DBBB Installation Guide download pdf (Page 12)

CAUTION:

Wear gloves to avoid cutting fingers on sharp edges.

English

D. ALIGNING THE WALL PLATE

Draw a vertical line on the wall at the center of the 30” (76.2 cm) wide space.1.

Use the mounting plate 2. as the template for the rear wall. Place the mounting

plate on the wall, making sure that the tabs are touching the bottom of the

cabinet or the level line drawn in Step C for cabinets with front overhang.

Line up the notch and centerline on the bottom of the mounting plate to the

centerline on the wall.

While holding the mounting plate with one hand, draw circles on the wall 3.

at holes A, B, C and D (see illustration above/actual plate marked with

arrows). Four holes must be used for mounting.

NOTE: If neither C nor D is in a stud, find a stud somewhere in area E and

draw a fifth circle to line up with the stud. It is important to use at least one

wood screw mounted firmly in a stud to support the weight of the microwave.

Set the mounting plate aside.

Drill holes on the circles. If there is a stud, drill a 3⁄16” hole for wood screws. 4.

For holes that don’t line up with a stud, drill a 5⁄8” hole for toggle bolts.

NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.

Draw a Vertical

Line on Wall

from Center of

Top Cabinet

Area E

Hole A

Hole B

Hole D

Hole C

Centerline

Notches

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

No comments

Haier HMV1630DBBB Installation Guide Page 12