Haier QBJ1-150A58E User Manual download pdf (Page 9)

Assembly Instruction

Glass tube assembly

1. Keep tubes out of the irradiation while assembling the unit or a scald may be

caused.

2. Place the rounded side of rubber seal downwards on the open end of tubes.(A)

3. Insert the tube into base support of locating hole with gentle pressure and twisting

motion.

4. Holding the tube, fix base support into base bracket (B), insert tube into base

support (C).

5. Slide the tube down 1 cm, Slide black rubber seal up the tubes until it sits flush

with tank(D).

6. Insert one tube on either end of the tank to achieve alignment of unit.

Notice:

1. Make sure the silicon seal ring are clean and well positioned.

2. Place the rounded side of rubber seal downwards on open end of tube.

Slide it down 10 cm. Wet open end of tube to make it easier to insert.

Silicon seal ring

Rubber seal

Evacuated tubes

Evacuated

tubes

Rubber seal

hold position

Base support

Base bracket

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Haier QBJ1-150A58E User Manual Page 9