Haier HPU-42CF03 User Manual download pdf (Page 7)

Clock Set

Displays when healthy run function is set.

22.TEMPERATURE Display

34.LOCK State Display

33.BATTERY Energy Display

Notify the user when it is time to change

the batteries.

24.HIGN/SO Run Display

26.SIGNAL SENDING Display

28.Fresh Display

29.Auxiliary ELECTRICAL HEATING Display

30.HEALTH Display

32.SLEEP State Display

31.Operation MODE Display

AUTO RUN

COOL RUN

DRY RUN

HEAT RUN

FAN RUN

35.FAN SPEED Display

23.AUTO SWING Display

20.TIMER Display

21.FILTER Display

36.TIMER ON Display

When unit is started for the first time and after replacing batteries in remote

controller, clock should be adjusted as follows:

1.Press CLOCK button, clock indication of " AM " or " PM " flashes.

2.Press or to set correct time. Each press will increase or decrease

1 min. If the button is kept pressed, time will increase or decrease quickly.

3.After time setting is confirmed, press "SET" : AM or PM stop flashing,

while clock starts working.

Note:AM means morning and PM means afternoon.

When operating the remote controller in an area where

electronically controlled lights are installed or wireless

handsets are used, please move closer to the indoor unit

as the function of the remote controller might be affected

by signals emitted by the above mentioned equipments.

Battery loading

Confirmation indicator

If no indication is displayed after press ON/OFF button,

reload the batteries.

Remote Controller Operation

When in use, direct signal transmission

head to the receiver placed on the

indoor unit

The distance between the remote controller and the receiver

should be max 7m and there should be no obstacle between

them.

Do not throw the remote controller; prevent it from being damaged.

17.SLEEP Button

(The clock must be corrected before setting sleep function)

Used to set sleep mode.

18.FAN Button

Used to select fan speed:LOW,MID,HIGH,AUTO.

19.TIMER OFF Display

When the filter need be cleaned, the sign will

appear automatically.

25.Code A display

Code A is used for this unit

27.Code B display

Parts

AUTO

LOW

MED HIGH

HEAT

FRESH

HIGH/SO

TIMER

SET

FILTER

HEALTH

RESET

LOCK

SLEEPMODE

CLOCK

CODE

LIGHT

Battery loading

Batteries are fitted as follows:

Loading the battery

Ensure that batteries are correctly placed in the

compartment as required for positive and negative

terminals.

Replacing the battery compartment lid

The battery compartment lid is reinstalled in the reverse

sequence.

Display review

Press the button to see if batteries are properly fitted. If

no display appears, refit the batteries.

Remove the battery compartment lid

Slightly press and disengage the battery compartment lid

marked with ì

î and then hold the remote controller by

the upper section and then remove the battery compartment

lid by pressing in the direction of the arrow as shown in

the figure above.

+ -

- +

Note:

It is recommended that the batteries be removed from

the compartment if the remote controller is not used for

an extended period.

The remote controller is programmed for automatic test

of operation mode after the batteries are replaced. When

the test is conducted, all icons will appear on the screen

and then disappear if the batteries are properly fitted.

When throw away the waste batteries,please perform

in accordance with the local regulation.

Caution:

If the remote controller does not operate as designed after

fitting new batteries of the same

type, press the Reset button (marked ) with a pointed

article.

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

Comments to this Manuals

No comments

Haier HPU-42CF03 User Manual Page 7

Comments to this Manuals

Related products and manuals for Split-system air conditioners Haier HPU-42CF03