Haier DD410RS Use and Care Manual download pdf (Page 10)

49-60810-1

INSTALLATION INSTRUCTIONS

ENGLISH

STEP 2 - PREPARE DUAL-DRAWER REFRIGERATOR

STEP 3 - INSTALL DUAL-DRAWER REFRIGERATOR

1. Pull open the upper drawer. Remove the crisper bins and set aside.

2. Using two hands, lift up on the metal drawer divider rod to remove it from

the slots in the front and rear of the drawer.

3. Once the drawer divider rod is out of the slots, turn the rod so that it is at

an angle to the front of the drawer. Lift the rod slowly out of the drawer

to avoid bumping into the control panel, and then set aside the divider

assembly.

4. Close the upper drawer to avoid damage during installation.

Depending on the material of your countertop, use either Method 1 - Install

to Countertop or Method 2- Install to Adjacent Cabinet to secure your dual-

drawer refrigerator.

METHOD 1 - INSTALL TO COUNTERTOP

Attach the Anti-Tip Brackets

1. Pry hole covers from the top of the

refrigerator cabinet to reveal the

holes used to install the anti-tip

brackets.

2. Open the upper drawer and leave it

open to install the anti-tip brackets.

3. Remove the anti-tip brackets and

screws from the accessory bag.

4. With the screws provided, fasten the anti-tip brackets to both sides of

the top of the cabinet.

WARNING

Tip Over Hazard

Do not use dual-drawer refrigerator until completely installed.

Do not push down on open drawer.

Failure to follow these instructions can result in serious injury or cuts.

Anti-Tip

Bracket

Screw

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

No comments

Haier DD410RS Use and Care Manual Page 10