Haier HCH2100ACS Owner's Manual download pdf (Page 7)

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting installation. Read and follow the

instructions provided with any tools listed here.

Tools needed

•

Level

•

Drill with 1¼", ¹⁄₈", and ⁵⁄₁₆" Drill Bits

•

Pencil

•

Wire Stripper or Utility Knife

•

Tape Measure or Ruler

•

Pliers

•

Caulking Gun

•

Caulking Compound (weatherproof)

•

Vent Clamps

•

Jigsaw or Keyhole Saw

•

Flat-blade Screwdriver

•

Metal Snips

•

Phillips Screwdriver

•

Metric Hex Key Set

For non-vented (recirculating) installations, you will also need:

•

6" (15.2 cm) dia. round metal vent duct - length required is determined by ceiling

height.

Parts supplied

Remove parts from packages. Check that all parts are included.

•

120 V Power Cord (with 3 prong plug)

•

Hood Canopy Assembly (blower, vent

transition, light bulb and canopy glass

[pre-installed])

•

Metal Grease Filter

•

Vent Cover Support Bracket

(attached to vent cover)

•

Two-Piece Vent Cover

•

4 x 8 Screws (4)

•

5 x 45 mm Mounting Screws (6)

•

8 x 40 Wall Anchors (2)

•

10 x 50 mm Wall Anchors (4)

LOCATION REQUIREMENTS

IMPORTANT: Observe all governing codes and ordinances.

Have a qualied technician install the range hood. It is the installer’s responsibility to

comply with installation clearances specied on the model/serial rating plate. The

model/serial rating plate is located behind the left lter on the rear wall of the vent

hood.

Canopy hood location should be away from strong draft areas, such as windows,

doors and strong heating vents.

Grounded electrical outlet is required. See “Electrical Requirements” section.

1 2 3 4 5 6 7 8 ... 68

Comments to this Manuals

No comments

Haier HCH2100ACS Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Cooker hoods Haier HCH2100ACS