Haier HAPE200 User Manual download pdf (Page 11)

English

Changing The Carbon Pre-Filter

When the Pre-Filter exceeds 4000 hours, the Pre-Filter Life Counters will display

100% life used and you should replace the pre-filter. To maintain proper odor-

removing capability and overall filtration performance, the pre-filter should be

changed every 4000 hours (approximately 6 months of use). If necessary, the

pre-filter can be changed more often. Proper maintenance of the pre-filter will

help extend the life of the HEPA filter. Refer to Replacement Filter Value Pack, for

importance associated with replacing filters regularly.

How To Change The Pre-Filter and Reset The Pre-Filter Life Counter:

1. First, turn off and unplug the air purifier.

2. Next, remove the front grill. Place your fingers in the hand recess located on

the bottom of the grill and pull firmly.

3. The pre-filter is attached to the inside of the grill with hook tape. Pull gently

on the pre-filter to remove it.

4. If needed, use a soft damp cloth to wipe of the grill.

5. Install the new pre-filter by placing it in the grill and pressing gently on the

pre-filter so that it adheres to the hook tape. You may notice a few black

particles coming off the pre-filter. Those particles are part of the odor-

removing activated carbon and will be collected on the filter during regular

use.

6. Install the grill back onto the unit. First, insert the top grill tabs into their

mating slot holes on inside edge of the front of the unit, and then push the

the grill forward until it engages with the bottom of the unit, as shown in

fig 4.

7. Plug in the air purifier.

NOTE: This unit will not operate unless the grill is in the correct position.

This is a safety feature.

8. Finally, reset the Pre-Filter Life Counter by pressing the key for

2 seconds. The Pre-Filter Counter will return to 0%.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

No comments

Haier HAPE200 User Manual Page 11