Haier HT18TS45SW Owner's Manual download pdf (Page 11)

DOOR HANDLE INSTALLATION

For refrigerators without a mounting screw

installed on the face of both doors:

Remove both handles from the freezer

compartment and the screws and handle trim

pieces from the parts-included bag.

FREEZER DOOR HANDLE

1. Mount the tapered end of the handle to the

door face using the enclosed screw. Do not

use the screw hole closest to the center of the

handle.

2. Attach the flat end of the handle to the

underside of the door using the enclosed

screws.

3. Insert tab on handle trim cover into slot in

handle and then press firmly onto handle.

REFRIGERATOR DOOR HANDLE

1. Mount the tapered end of the handle to the

door face using the enclosed screw. (Fig. 3) Do

not use the screw hole closest to the center of

the handle.

2. Attach the flat end of the handle to the top of

the door using the enclosed screws. (Fig. 4)

3. Insert tab on handle trim cover into slot in

handle then press firmly onto handle. (Fig. 5)

4. If re-installing handles after reversing the

door swing, remove the screw hole plug from

the parts-included bag and place it in the

handle-mounting screw hole on the face of the

refrigerator door.

5. The name badge can be removed by using a

putty knife or flat head screwdriver to pry the

badge off the door face, being careful not to

damage the finish. Any residue left on the face

of the door from the badge should be removed

by using Goo Gone

©

or WD-40

©

. Be sure to

follow the manufacturer’s instructions when

using these products.

Do not use any abrasives or scouring pads to

remove the residue.

An extra logo badge is provided in the parts-

included bag with your refrigerator. That badge

can be used to cover the handle-mounting screw

hole on the face of the freezer door.

PAGE 9 • SET UP & USE

ENGLISH

DOOR HANDLE INSTALLATION CONT.

Fig. 3

Fig. 4

Fig. 5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 71 72

Comments to this Manuals

No comments