Haier HT18TS45SW Owner's Manual download pdf (Page 7)

LEVELING YOUR REFRIGERATOR

• Your refrigerator has two leveling legs that are located in the front bottom corners of your refrigerator.

After properly placing your refrigerator in its final position, you can level your refrigerator.

• Leveling legs can be adjusted by turning them counterclockwise to raise your refrigerator or by turning

them clockwise to lower your refrigerator. The refrigerator door will close easier when the leveling legs

are extended.

PROPER AIR CIRCULATION

• To ensure your refrigerator works at the maximum efficiency it was designed for, you should install it in

a location where there is proper air circulation, plumbing and electrical connections. Your refrigerator

is not designed to operate in temperatures below 55˚F (12˚C ) or above 95˚F (35˚C).

• Do not install your refrigerator in any location not properly insulated or heated, e.g. garage, etc.

Keep out of direct sunlight and away from heating sources such as radiators, heaters, and cooking

appliances.

• The following are recommended clearances around the refrigerator:

Sides……………1” (25 mm) Top....................1" (25 mm) Back..................2" (50mm)

ENGLISH

PAGE 5 • SET UP & USE

INSTALLATION GUIDE CONT.

INSTRUCTIONS FOR UNPACKING

FRONT GRILLE

Your refrigerator comes with a front grille (toe kick), which is reversible based on which side of the

refrigerator the hinges are mounted on. To install the front grille, locate the non-hinge end using the

diagram below and follow the instructions below.

1. Snap the non-hinge side into the air flow opening on the lower rail of the refrigerator.

2. Then, snap the hinge side into the opposite air flow opening in the lower rail beside the bottom hinge.

LOWER RAISE

Non-hinge side Hinge side

Non-hinge side

Hinge side

1 2 3 4 5 6 7 8 9 10 11 12 ... 71 72

No comments

Haier HT18TS45SW Owner's Manual Page 7