Haier HLP24E Use and Care Manual download pdf (Page 11)

STEP 2 - CONNECT AND SECURE THE DRAIN HOSE

1. Enlarge the opening by squeezing the

ends of the drain hose clamp together.

Slide the clamp over the end of the drain

hose,andontotheexiblesectionofthe

hose.

2. Fit the end of the drain hose over the

plastic drain port extending from the

washer.

3. Squeeze the ends of the clamp to enlarge

the opening and slide the clamp over the

connection of the drain hose and drain

port. Release the clamp to tighten.

4. Put the drain hose hook end in a drain pipe or laundry tub.

5. Secure the drain hose in place by fastening it to a water hose, the standpipe, or a

leg on the laundry tub. See “Drain System Requirements” for illustrations.

STEP 3 - CONNECT THE WATER HOSE

IMPORTANT: Only use a new hose when installing the washer.

NOTE: Periodically inspect hose for cracks, cuts, leaks or wear. Replace with new

hose every 5 years.

1. Checkthataatwasherispresentandrmlyinplaceineachendofthewater

inlet hose. Flat washers are pre-installed at the factory.

Washer

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 69 70

No comments

Haier HLP24E Use and Care Manual Page 11