The exit end face of the faucet
Confirm the water faucet
Connection between the water inlet hose jointer and the water faucet
water faucet, suitable water faucet, not suitable
It is required that the front end shall be longer than 10mm.
The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage.
2 Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet.
See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen
the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth, otherwise
it may leak water. See to Figure 3.)
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the
water inlet hose component. See to Figure 1.
3.Fasten the four screws evenly. See to Figure 4.
about 4mm after twisting
Remark: .Before twisting the fastening nut, the threading is 4mm above the upper
surface of the nut. After twisting, the threading is less than 2mm above the upper
surface of the nut. See to Figure 6
About above 2mm after twisting
water inlet hose jointerwater inlet hose jointer
Screw knife
Screw
Bushing
Nameplate
Screw nut
water inlet hose
Figure 1
Figure 4
Figure 2
Figure 5
Figure 3
Figure 6
Slider
Lock level
Install the water inlet hose
4 Take off the nameplate. Twist the fastening nut as per the indication of the figure
to seal up the exit end face of the faucet. See to Figure 5.
Before Using
Before Using
5
Page 11
POWER
ON/OFF
PROGRAM
WASH
RINSE
SPIN
TIMES
Steps of using the operation buttons and description of the steps
Push the "POWER ON/OFF " button to switch on the power.
2
Push the
"PROGRAM"
button
to select suitable automatic program.
After switching on the power, the machine will set standard program automatically. To select other automatic
program, push the "program" button till the relative indicator is on. Refer to the "program button" on Page
11 for the selection.
For instance: select "SAVE" program for laundries with small quantity
and light soil.
In selecting the standard program, the machine
will execute fuzzy program to select water
and wash time according to the cloth and weight
of the laundries. The full procedure is controlled
automatically.
Push the "SOAK","WASH", "RINSE" or "SPIN"button to select suitable procedure.
MINUTES MINUTESMINUTES
SOAK
Using process
Using process
12
COTTON
TUB CLEAN
SILK
BLANKET
SAVE
DRY-CLEANING
WOOLLEN
STANDARD
TIMES
WA
S
H
R
IN
S
E
MINUTES
MINUTES
MINUTES
S
O
A
K
HWM90-96A
S
P
I
N
+
WATER LEVEL
START
PAU SE
POWER
ON/OFF
PROGRAM
RESERVE
RESERVE(HOURS LATER)
TIME REMAINED(MINUTE)
COTTON
TUB CLEAN
SILK
BLANKET
SAVE
DRY-CLEANING
WOOLLEN
STANDARD
(18L)
MIN
Su
per-power digi
ta
l int
el
ligent control
Digital tub display
10 water level selection
12 mins quick wash
nano wash
(21 pages)
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals