Haier Washer HWM100-828A User Manual download pdf (Page 3)

Meaning and description of the symbols

Contents marked with that symbol are actions forbidden

to perform. Performing of those action may result in damage of

the machine or influence the personal safety of the users.

Contents marked with that symbol are related to the

safety of the product and the personal safety of the users.

Please operate in strict conformity to the contents.

Names of the parts

Warning sign

Forbidden sign

Phenomena The reason How to settle

Trouble-shooting answer to question

(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns

sometimes. Please confirm again before sending it to repair. Do not repair it by yourself.

The digitron displays E0.

The safety switch acts, and the

spinning cannot work. The

digitron displays E3.

The water filling does not work,

the digital displays E4.

The drainage cannot work, or is too slow.

The digitron displays E1.

It stops running in midway. The digitron

displays E2.

The top lid is not closed.

The top lid is opened during reserve procedure.

Close the top lid.

Is the drain hose put down?

Is the drain hose blocked?

Put down the drain hose. Open and close the top lid once.

Clean the foreign material. Open and close The top Lid Once.

Are the laundries put slantingly?

Is the machine slanting?

Reorder the laundries. Close the top lid.

Th machine will start running after 10

seconds of being placed horizontally.

Is the water tap opened, or is there water

supply failure?

Is the water inlet valve blocked?

Is the water pressure too low?

Open the water tap. Push the start/Pause

button once.

Clean the water inlet valve then push

the Start/Pause button once.

Push the Start/Pause button once.

The water level sensor is bad.

Please contact the after-sales

service department.

The digitron displays E6.

The machine does

not act

Not wash

Not spin

Is there power failure?

Is the power plug inserted tightly?

Is the water level reached preset position?

Please use it when there's power supply.

Insert the power plug tightly.

Fill water to the preset position.

Is the power plug inserted tightly?

Is the top lid closed reliably?

Are the laundries set flat?

Insert the power plug tightly.

Close the top lid.

Set the laundries flat.

There's abnormal sound

inside the machine

The water tap leaks

Is the machine slanting?

Are the laundries put slantingly in spinning?

Are there any foreign materials?

Adjust the machine to be even

Reorder the laundries and close the top lid.

Remove the foreign materials.

Is the screw of the jointer of water

inlet hose loose or awry?

Fasten the screw of the jointer properly.

Common phenomena

Phenomena Explanation

Balance the laundries to avoid slanting.

The cloth sensor is checking the cloth, it willadd waterafter 48 seconds.

The program is setting the drain time. Some time is needed

before it starts spinning.

The spinning is intermittent when it starts.

The wash procedure is paused.

The pulsator pauses during water inlet

in wash and rinse.

There may be some water flowing out of the

drain hose in the first use of the machine.

Push the PROGRAM button to select SPIN,

but it doesn't work.

It is to avoid splashing during water inlet.

It is the water remained in the factory inspection of performance.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Haier Washer HWM100-828A User Manual Page 3

Comments to this Manuals

Related products and manuals for Washing machines Haier Washer HWM100-828A