Haier Washer HWM100-828A User Manual download pdf (Page 4)

Safety precautions

The ventilation

holes at the bottom

Carpet

Do not let the machine share one receptacle with other

electric appliances. If the plugging into the receptacle

is loose, do not use the plug any more.

Do not wash water-proof laundries like

the raincoat, bike covers etc. to avoid

abnormal vibrations in spinning.

Do not bend ,extend, twist, bind by force. Do not press or nip it with weight.

Keep the pin of the power plug clean, if the power plug is polluted with dust, please wipe with

dry cloth carefully.

If the power cord or the power plug is bad, to avoid risk it is required to have it replaced by

the technicians of our special shop or our customer care agent.

Do not put the machine at damp place like

the bathroom. Never wash it with water. Do

not put wet laundries on the control panel.

Do not use water hotter than 50 .

In case the washing machine is installed on ground with

carpet, do not block the ventilation hole with carpet.

Please plug the power plug on special

receptacle. Be sure to use three-pins

power receptacle. Ensure that the earthing

prong of the power receptacle is earthed

reliably. Use leakage protector if possible.

The washing machine must be positioned so that

the plug is accessible. Be sure to pull the plug off

and close the water faucet in following cases:

power failure, delivering the machine, setting the

machine idle or cleaning the machine. Do not plug

or pull the power plug with wet hand.

Disposal after washing

After using, please clean the lint and foreign materials of the lint filter etc. in time.

Otherwise it may influence your using the machine.

Please first pull off the power plug from the receptacle before cleaning.

Clean the detergent box and set it on

the control panel seat.

1.The method of dismantle: Push it up aslant and gently.

2.The method of install : install it upwards and aslant

and push it in .

The filter screen of the water inlet valve is likely to be

blocked by foreign materials and influence the water

inlet.

Please clean it with brush every two months.

If the cabinet is dirty, wipe it with wet cloth

Do not flush it directly with water.

Wipe it with neutral detergent.

Do not wipe it with thinner, petrol, alcohol etc.

Lint filter:

The lint filter must be used during washing.

It must be cleaned in time after each using.

Figure 1

Figure 2

Down

Dismantle

Install

The back cover of lint filter

Install

Dismantle

Down

The front cover of lint filter

1.Push down the spring piece of the top lint filter

to make the claws out of the filter cover, and then

pull out the lint filter to get it down. figure1

2.Pull the back of the lint filter, and then you can

get down it off the front cover of the lint filter. figure2

3.Sweep the rubbish in the lint filter.

4.Put the back of the lint filter into the front cover .

5.Put the lint filter into filter cover, and make it

tight .

6.Make sure the lint filter well installed, or it can

influence your use.

1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).

5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time

(about 1 hour), then close the top lid.

4.Hang up the power cord and drain hose.

3.Be sure to pull off the power plug before maintenance.

2.Do not store water in the washing machine for a long period. Drain the water completely after each using.

Petrol

Alcohol

Dismantle Install

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Haier Washer HWM100-828A User Manual Page 4

Comments to this Manuals

Related products and manuals for Washing machines Haier Washer HWM100-828A