Haier WDNS116BBS User Manual download pdf (Page 8)

English

ELECTRONIC CONTROL:

Display Instructions

1. Stand-by status: On initial set-up,

pressing ON/OFF button, the clock

will display “00:00”.

2. Heating Function: Heating indicator

will flash on the display, until

the temperature reaches the set

temperature, then heating indicator

will stop flashing.

3. Heating Level: When setting the

heating temperature, additional bars

will be added as you increase the

heating temperature from 190°F

(Min) to 203°F (Max). The default

temperature is 197°F.

4. Cooling Function: Cooling indicator

will flash on the display, until

the temperature reaches the set

temperature, then cooling indicator

will stop flashing.

5. Cooling Level: When setting the cooling temperature, additional bars will be

added as you increase the cooling (decreasing temperature) from 50°F (Min)

to 43°F (Max). The default cooling temperature is 44.6°F.

6. Anti-Overheat Indicator: When water dispenser is heating, if the hot water tank

is out of water, the water dispenser will stop heating and the Anti-Overheating

indicator and left 2 bars on the Heating Level and right 2 bars Cooling Level

displays will flash. When the Anti-Overheating indicators flash, fill the water

tank and follow Start-Up Instructions.

7. Troubleshooting display: when the screen shows the left and right bars of the

Heating Level display flashing, it shows a heating sensor problem. When the

screen shows the left and right bars of the Cooling Levels display flashing, it

shows a cooling sensor problem. Turn off and unplug the water dispenser then

follow the Start-Up Instructions.

BUTTON INSTRUCTIONS

1. ON/OFF: Press the ON/OFF button and the water dispenser will power ON

and be in Stand-by mode. PLEASE NOTE: You need to press the Hot/+ (#4

below) button to turn on the water heater and the Cold/- (#5 below) button to

turn on the cooling compressor. When in stand-by mode, pressing the ON/

OFF button will cut off all power.

2. Set function: While the dispenser is in stand-by mode, press and hold the

Set button for 2 seconds, the display will go into Set Mode. In Set mode

you will be able to set the clock time, hot water temperature and cold water

temperature.

HOT WATER

ON/OFF SET

HOT/+ NIGHT LIGHT COLD/-

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Haier WDNS116BBS User Manual Page 8

Comments to this Manuals

Related products and manuals for Water equipment Haier WDNS116BBS