Haier HT18TS45SW User Manual download pdf (Page 6)

ELECTRICAL REQUIREMENTS

INSTALLATION GUIDE

PAGE 4 • SET UP & USE

ENGLISH

GROUNDING INSTRUCTIONS

• Make sure there is a suitable power outlet. 115 Volts, 15 Amps, 3 Prong (Grounded) power outlet with

proper grounding to power the refrigerator.

• Avoid the use of three prong adapters or cutting off the third grounding prong in order to

accommodate a two prong outlet. This is a dangerous practice since it provides no effective grounding

for the refrigerator and may result in shock hazard.

USE OF EXTENSION CORDS

• Avoid the use of an extension cord because of potential safety hazards under certain conditions.

If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade

grounding plug and a 3-slot outlet that will accept the plug. The marked rating of the extension cord

must be equal to or greater than the electrical rating of the appliance. DO NOT USE EXTENSION

CORD LONGER THAN 12 FT.

INSTALLATION LIMITATIONS

• Select a suitable location for the refrigerator on a hard even surface away from direct sunlight or heat

source, e.g. radiators, baseboard heaters, cooking appliances, etc. Any floor unevenness should be

corrected with the leveling legs located on the front bottom corners of the refrigerator.

UNPACKING YOUR REFRIGERATOR

1. Remove all packaging material. This includes the corrugated base and all adhesive tape holding the

refrigerator accessories inside and outside.

2. Inspect and remove any remains of packing, tape or printed materials before powering on the

refrigerator.

NOTE: If your refrigerator comes with a snack pan, remove the blue adhesive tape from the rear of the

pan. The pan will not slide in and out without removing the tape.

USE OF EXTENSION CORDS- POTENTIAL SAFETY HAZARD

WARNING

ELECTRICAL REQUIREMENT - SHOCK HAZARD

WARNING

1 2 3 4 5 6 7 8 9 10 11 ... 71 72

No comments

Haier HT18TS45SW User Manual Page 6