Haier Dishwasher DW12-TFE2 User Manual download pdf (Page 17)

End of programme

Interrupting the programme

Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open

the door fully until spray arm has stopped rotating.

When you open the door, the dishwasher will beep ten times every thirty seconds.

If the appliance has already heated up or the hot water was switched ON and then the appliance door

opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may

open due to expansion.

Delayed start programming (DW12-TFE3 Series)

You can delay the start of a programme in increments of 1 hour up to 24 hours.

Switch dishwasher ON.

Immediately press the Delayed Start button “ F ”, the delayed start indicator “ E ” blinks, the remain-

ing time indicator “ G ” changes to “ ”.

Press the Delayed Start button for 2 seconds until the numerical display show the required delay.

To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator

“ E” goes out.

Rotate programme knob “ J ” to select the desired programme.

Close the door after loading the appliance.

Notice:

When the appliance is already underway press the button "B" for 3 seconds, all of

the settings will be cancelled.

Switching the dishwasher OFF

Several minutes after the programme has ended:

Set On-Off button to Off

Open the door .

Turn the water tap off.

Remove dishes, etc. when they have cooled down.

Six beeps will indicate that the wash cycle has finished and the state indicators "A" light.

D F

Kalt

1 ... 16 17 18 ... 53

No comments

Haier Dishwasher DW12-TFE2 User Manual Page 17