Haier DW-7777-01 User Manual download pdf (Page 10)

English

YOU MUST HAVE

• A hot water line with 20-120 psi (138-862 kPa) water pressure.

• Inlet water temperature 120º F(49º C) minimum at the dishwasher is

recommended.

• ” (0.9cm) O.D. tubing with compression fitting or flexible stainless steel

braided fill line (” (1.3cm) minimum plastic tubing is optional but not

recommended).

• A 90º elbow with ” (0.9cm) N.P.T. external pipe threads

on one end. Do not solder within 6”(15.2cm) from water inlet

valve.

WATER

YOU MUST HAVE

• Use the new drain hose supplied

with your dishwasher. If this is not

suitable, use a new drain hose

with a maximum length of 12

feet (3.7m) that meets all current

AHAM / IAPMO test standards,

is resistant to heat and detergent,

and fits the drain connector on

your dishwasher.

• Have a high drain loop 30 inches

(76.2cm) above the subfloor or

floor.

• Connect drain hose to waste tee

or disposer inlet above drain trap

in house plumbing and 20 inches

(50.8cm) minimum above the floor.

• Use an air gap in the drain line if the drain hose is connected to house

plumbing lower than 20 inches (50.8cm) above subfloor or floor.

• Use ” (1.3cm) minimum I.D. drain line fittings.

DRAIN

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 83 84

No comments

Haier DW-7777-01 User Manual Page 10